HVOF 2200/2800 Gun

Metal Coat HVOF 2200 and Metal Coat HVOF 2800 gun has been developed to produce high integrity coatings of metals, alloys, superalloys and carbides. Coatings sprayed with our HVOF spray gun exhibit high density, low oxide content, superior microhardness and high adhesion with excellent machinability.

Our gun can be supplied with a water-cooled front section, which allow the gun to produce higher particle velocities, maximizing coating substrate and interparticle bonding. In general, water-cooled gun also have higher coating densities, higher hardness and lower oxide content.

The standard, water-cooled guns consume minimal quantities of water, with only potable (drinking water) quality required at line pressures as low as 2.76 bar (40 psi). Material spray rates, depending on gun configuration and material applied, can be as high as 150 g/min (20 lb/h), thus reducing hvof spray times.

Machine-mount gun configurations are available for use with automated HVOF spray (thermal) systems as well as handheld models, which may be used with manual systems.

Features and Benefits
Reference Parameters
HVOF GUN HVOF -2200/2800
Weight 1.83 Kg.
Gases Oxygen, LPG/Propane, Air
CONTROL PANEL HVOF-CONTROL-PANEL
Dimensions 1570 x 610 x 200 mm
Weight 41.2 Kg.
Electricity 220 V / 1 P / 50/60 Hz , 110 V / 1 P / 60 Hz (Optional)
POWDER FEEDER MPF-700
Capacity 700 CC (3350 CC may also be used)
Weight 36.5 Kg
Electricity 110 V / 1 P / 60 Hz (Optional)
Gas Flow (LPM) Operating Pressure
Oxygen 250-350 10 Kg/cm2
LPG/Propane 160-80 7.0 Kg/cm2
Air 600-700 7.0 Kg/cm2
Powder Spray Rate Deposit Efficiency
WC-12Co 38 gm/min (5.01 lb/hour) 70%
WC-17Co 38 gm/min (5.01 lb/hour) 60%
WC-10Co-4Cr 38 gm/min (5.01 lb/hour) 70%
Cr3C2 -NiCr 25 gm/min (3.30 lb/hour) 58%
Standard System
Optional Accessories